|February 10, 2006, 01:09||
coordinate in Workbench
I am using Workbench to design the model. But I did not know how to set the coordinates of the line or circle. I only saw the x,y ordinate in table, but I cannot changed the ordinate.
For exampe, it is difficult the darw a square and a circle with the same center.
Thank you for you replaying.
At the same time, it is my pleasure to keep contact with you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|ANSYS Workbench on "Uncertified" Linux Distros||hsr||CFX||262||September 7, 2016 21:05|
|[ANSYS Meshing] Workbench 13: Structured Hexa Meshes||rooftop||ANSYS Meshing & Geometry||19||March 31, 2016 02:33|
|PEM Fuel cell module meshes. ICEM vs workbench||aarvay||FLUENT||22||January 26, 2016 00:47|
|cylindrical coordinate vs cartesian coordinate||Lam||FLUENT||10||May 11, 2013 13:05|
|Cording Ground.for in Cylindrical coordinate||J.H. Lee.||Phoenics||2||March 28, 2003 05:28|