 |
 |
 |
|
|
|
[Sponsors] | ||||
November 29, 2019, 22:17
|
where finding :quench flux?
|
#1 |
|
New Member
Join Date: Oct 2013
Posts: 16
Rep Power: 12  |
simulating a vertical Subcooled Boiling and the wall boiling model was used.when i do the postprocessing,i cannot find the quench flux and convective flux?where i can find? if using fluent do the simulation,i can see the three part heat flux. cfx can not show the three part heat flux? thanks for any help!
|
|
|
|
|
|
November 30, 2019, 04:19
|
|
#2 |
|
New Member
Zhipeng Yao
Join Date: Jul 2019
Location: Sydney
Posts: 4
Rep Power: 6 |
I found following relationships:
'Liquid.Wall Heat Flux'='Vapour|Liquid.Heat Flux to Liquid'≠0, 'Vapour|Liquid.Heat Flux to Liquid'+’Vapour|Liquid.Heat Flux to Vapour'='Wall Heat Flux', 'Vapor.Wall Heat Flux'=0, 'Vapour|Liquid.Heat Flux to Vapour'≠0. I think that Qq and Qc are included in 'Vapour|Liquid.Heat Flux to Liquid', and they may need to be represented by CEL. I am also confused about this, and hope to get a solution too. Last edited by Z.P. Yao; November 30, 2019 at 10:13. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
| My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
| How to use "translation" in solidBodyMotionFunction in OpenFOAM | rupesh_w | OpenFOAM Running, Solving & CFD | 5 | August 16, 2016 04:27 |
| Udf for moving heat flux in 2D cylindrical geometry | devia21 | Fluent UDF and Scheme Programming | 0 | April 20, 2015 00:27 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Linear Mode
