CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   mesh generation (

mike April 11, 2006 08:36

mesh generation
Guys, I need your expertise on mesh quality. I am using CFX mesh. And I want to use SST model. The manual states that I should put at least 15 nodes in the boundary layer. Is putting 10 inflated layer good idea or not? When I do that, there are too many flat elements, however increasing tets is not a solution for me at this point, since my domain is huge and it will not be feasible for me. (more than 2 million elements)(even with putting line controls, 15 node becomes very unreasonable.) Shortly, I want to ask you what you think about putting large number of inflated boundary.

Thanks alot, Mike

All times are GMT -4. The time now is 04:18.