Turbo region is not recognised

Julian121 · February 18, 2020, 08:18

I’m modelling an axial compressor that consists of inlet/igv/rotor/stator/casing treatment/outlet domains. I’m modelling two passages for every domain.
In CFD-Post, turbo region recognises only one domain and the rest are not recognised.
The two surfaces between the domains are modelled as an internal interface.
I tried to create a single boundary for every two similar boundary but it did not help. Does anyone know a solution?

Светлана · February 18, 2020, 17:57

Can you please post an example test case demonstrating this problem?

Julian121 · February 19, 2020, 01:56

Please see the image. CFX-Post only recognises a single domain as shown by the arrow.

Светлана · March 5, 2020, 18:51

Example "test case" - ansys workbench project - not a screenshot. Then I can attempt to figure out where the problem is. This is a bit difficult to resolve by looking at screenshots. Thank you.

February 18, 2020, 08:18	Turbo region is not recognised	#1
Julian121 Senior Member Join Date: Aug 2012 Posts: 268 Rep Power: 14	I’m modelling an axial compressor that consists of inlet/igv/rotor/stator/casing treatment/outlet domains. I’m modelling two passages for every domain. In CFD-Post, turbo region recognises only one domain and the rest are not recognised. The two surfaces between the domains are modelled as an internal interface. I tried to create a single boundary for every two similar boundary but it did not help. Does anyone know a solution?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem simulating the temperature rise in a composite material (chtMultiRegionFoam)	Adam_K	OpenFOAM Running, Solving & CFD	2	March 27, 2019 06:51
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 18:57
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 08:19

February 18, 2020, 17:57		#2
Светлана Senior Member Svetlana Tkachenko Join Date: Oct 2013 Location: Australia, Sydney Posts: 407 Rep Power: 14	Can you please post an example test case demonstrating this problem?

March 5, 2020, 18:51		#4
Светлана Senior Member Svetlana Tkachenko Join Date: Oct 2013 Location: Australia, Sydney Posts: 407 Rep Power: 14	Example "test case" - ansys workbench project - not a screenshot. Then I can attempt to figure out where the problem is. This is a bit difficult to resolve by looking at screenshots. Thank you.