Export whole impeller from bladegen

henriquempr · March 4, 2020, 15:59

I utilize vista CPD and Bladegen to criate a centrifugal impeller (with 6 blade), and the meshing. When I export from bladegen to meshing, it does not export the whole impeller, but, only a part corresponding one blade. Does anybody know how to export the whole impeller to meshing?.

I put this question, because I would like to simulate complete impeller.

Thanks

Rodrigo_Eng_Mect · March 4, 2020, 17:58

use the properties of the BladeGen file, select to import all the blades into the DM or 3D software

March 4, 2020, 15:59	Export whole impeller from bladegen	#1
henriquempr New Member Henrique Join Date: Jan 2020 Posts: 9 Rep Power: 7	I utilize vista CPD and Bladegen to criate a centrifugal impeller (with 6 blade), and the meshing. When I export from bladegen to meshing, it does not export the whole impeller, but, only a part corresponding one blade. Does anybody know how to export the whole impeller to meshing?. I put this question, because I would like to simulate complete impeller. Thanks Ionut G likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[foam-extend.org] foam-extend-4.0 gcc errors & maybe paraFoam	powerline332	OpenFOAM Installation	3	May 24, 2018 22:16
A CFX-POST error (ver 14.5.7)	wangyflp88	CFX	2	July 22, 2017 01:17
Out File does not show Imbalance in %	Mmaragann	CFX	5	January 20, 2017 11:20
Unable to install OpenFOAM 1.6-ext	Maimouna	OpenFOAM Installation	23	May 8, 2014 06:47
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 20:08

March 4, 2020, 17:58		#2
Rodrigo_Eng_Mect New Member A Join Date: May 2016 Posts: 21 Rep Power: 0	use the properties of the BladeGen file, select to import all the blades into the DM or 3D software