|
[Sponsors] |
April 24, 2006, 06:47 |
PVM Error
|
#1 |
Guest
Posts: n/a
|
Dear all: I used CFX Parallel PVM function, but it showd the following error. How do I fix this problem?
Error message: +--------------------------------------------------------------------+ | An error has occurred in cfx5solve: | | | | Unable to start the PVM daemon on host xpc7. This may indicate | | that the PVM daemon is already running on that host, or that it | | left files in /tmp on that host because it did not exit cleanly | | last time it was run. | +--------------------------------------------------------------------+ |
|
April 24, 2006, 16:04 |
Re: PVM Error
|
#2 |
Guest
Posts: n/a
|
You must have ended your simulation without the demon turned off. Go to /tmp and delete all the file(s) pv*, that should do it.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Accessing phi from a fvPatchField at same patch | johndeas | OpenFOAM | 1 | September 13, 2010 20:23 |
UDF: DEFINE_CG_MOTION for vertical jump motion of an electrode! | alban | Fluent UDF and Scheme Programming | 2 | June 8, 2010 18:54 |
checking the system setup and Qt version | vivek070176 | OpenFOAM Installation | 22 | June 1, 2010 12:34 |
POSDAT problem | piotka | STAR-CD | 4 | June 12, 2009 08:43 |