CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

boundary condition with user fortran

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   May 11, 2006, 12:19
Default boundary condition with user fortran
  #1
Lena
Guest
 
Posts: n/a
Hello,

I try do set a time- and locationdependent boundary condition for a 3D-simulation using a user fortran routine. That routine interpolates the values I need out of a table I got from a 2D-simulation.

My problem is, that if I check the interpolated values which my routine gives back to the calculation in the beginnig of a timestep are correct. But if I write a backup-file at the end of the same timestep, the values I get are different to the values i've set in the beginning of that timestep.

Does anybody know that problem ?
  Reply With Quote

Old   May 11, 2006, 15:33
Default Re: boundary condition with user fortran
  #2
Robin
Guest
 
Posts: n/a
Hi Lena,

Make sure you are looking at the "Hybrid" values at the boundary. The conservative values represent the control volume next to the boundary and will differ from the boundary value.

Regards, Robin
  Reply With Quote

Old   May 12, 2006, 03:50
Default Re: boundary condition with user fortran
  #3
Lena
Guest
 
Posts: n/a
Hi Robin,

That was actually my mistake!

Thanks a lot for helping me

Regards, Lena
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
user routine, user funcion, or fortran compile effect on the memroy? princeps11 CFX 1 May 13, 2009 19:37
User sclar boundary condition. shuqin FLUENT 11 February 22, 2006 21:58
user fortran: boundary conditions-transient simula Vanessa CFX 0 October 20, 2005 10:23
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues michele OpenFOAM Meshing & Mesh Conversion 2 July 15, 2005 05:15
The Boundary Condition about the Flat Plate boing Main CFD Forum 1 January 6, 2002 17:53


All times are GMT -4. The time now is 01:11.