Fatal Error -- Help!

May 5, 2006, 10:35

Does anybody know what may cause the following solver error, other than what is suggested by the message. There are no elements or nodes at r=0 in either domain, let alone at their interface.

ERROR #001100279 has occurred in subroutine ErrAction. Message:

****** FATAL ERROR ****** The orthographic view transformation failed on domain interface "Interface". Failure may be due to r=0 included in transformed cylindrical coordinates of an interface with rotational relative motion.

May 7, 2006, 13:36

Do you use 'expression' in CFX-Pre? If you do, check if there is any case that is devided by 'r'.

May 5, 2006, 10:35	Fatal Error -- Help!	#1
Steve Roberts Guest Posts: n/a	Does anybody know what may cause the following solver error, other than what is suggested by the message. There are no elements or nodes at r=0 in either domain, let alone at their interface. ERROR #001100279 has occurred in subroutine ErrAction. Message: **** FATAL ERROR **** The orthographic view transformation failed on domain interface "Interface". Failure may be due to r=0 included in transformed cylindrical coordinates of an interface with rotational relative motion.

May 7, 2006, 13:36	Re: Fatal Error -- Help!	#2
Atit Guest Posts: n/a	Do you use 'expression' in CFX-Pre? If you do, check if there is any case that is devided by 'r'.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] gambit fatal error	bugra	ANSYS Meshing & Geometry	2	September 16, 2010 05:19
Foam fatal error	weninb	OpenFOAM	0	June 15, 2009 22:45
Which is the fatal error when foamInstallationTest	eddy	OpenFOAM Installation	2	March 30, 2008 21:13
Fatal error error writing to tmp No space left on device	maka	OpenFOAM Installation	2	April 3, 2006 08:48
error while compiling the USER Sub routine	CFD user	CFX	3	November 25, 2002 15:16