|
[Sponsors] |
May 10, 2006, 19:53 |
Multi-domain
|
#1 |
Guest
Posts: n/a
|
In my simulation i have only one domain, if i divide this domais into tow, my simulation will go faster?
THX FOR HELP? |
|
May 11, 2006, 01:33 |
Re: Multi-domain
|
#2 |
Guest
Posts: n/a
|
HI,
i think it will be slower cos there is a need for interfacing. i had a problem where i have almost 100 sub-domains and each subdomains have element scatteredd (i.e. disjointed) it cannot even be imported into CFX from ICEM. |
|
May 11, 2006, 07:00 |
Re: Multi-domain
|
#3 |
Guest
Posts: n/a
|
I assume you meant running your case in parallel. If you run a calculation using more than one processor, first thing you need to check is what would be your mesh size. If your mesh size is large, it would be faster using more machine working together. It depends on percentage of mesh 'overlap' between each partition. If computing overhead is not due to large mesh size (for example, due to radiation calculation), running in parallel is not going to be helpful, may slow down, as jemteo pointed.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 06:57 |
CFX domain comparison | Kiat110616 | CFX | 4 | April 3, 2011 23:43 |
Error Message after switching to multi domain physics | chili023 | CFX | 3 | June 5, 2010 06:28 |
Multi flow in two different domain | arunss | CFX | 3 | May 11, 2010 17:06 |
multi domain heat transfer prob | mohammed zubair | CFX | 1 | June 27, 2006 10:30 |