|
[Sponsors] |
May 18, 2006, 22:10 |
solidification and fluid flow modelling
|
#1 |
Guest
Posts: n/a
|
Dear all:
How to use ansys cfx10.0 to simulate solidification and fluid flow?I would appreciate if anyone can give me some advice. It was said that just CEL can set up the modelling,Is it true?I am not good at FORTRAN language. Thanks in advance. Jason |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
About the solidification? | H.P.LIU | Phoenics | 1 | December 1, 2010 10:49 |
Looking for software for free surface flow | Eric Jiang | Main CFD Forum | 12 | December 18, 2007 00:39 |
Solidification / Multiphase CFD | Roger Yang | Main CFD Forum | 0 | November 30, 2006 10:56 |
Unphysical solidification | Thomas | Phoenics | 4 | November 11, 2001 07:45 |
Upwinding 2-D fluid flow | shahriar afkhami | Main CFD Forum | 3 | September 19, 2000 20:34 |