CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   ask for help about CFX mesh (

Eric May 29, 2006 03:05

ask for help about CFX mesh
Dear Sir,

I use CFX-mesh to generate Mesh. But the mesh quality is not good( verified in CFX-Post). Could you give me some advice on how to set paramrters in CFX-mesh?

My model: Length of the cylinder is 11.4 mm, diameter is 2.8 mm, at the center of the cylinder is a hole(1.4 mm) as inlet. Two ends of the cylinder is outlet.

Please help me.Many thanks. Eric

All times are GMT -4. The time now is 06:15.