ERROR #001100279
 

hi all, cfx solver have given the following error when running parallel on unix platform after 286 of iteration and i don't know what to do . could anybody explain me how i overcome that error.

regards charles

OUTER LOOP ITERATION = 286 CPU SECONDS = 1.521E+05

Equation Rate | RMS Res | Max Res | Linear Solution |

l U-Mom 0.87 | 5.4E-04 | 9.8E-02 | 7.1E-02 OK|

| V-Mom 0.94 | 5.7E-04 | 1.4E-01 | 2.5E-02 OK|

| W-Mom 0.96 | 2.0E-04 | 2.4E-02 | 2.6E-02 OK|

| P-Mass 2.25 | 2.7E-04 | 2.0E-01 | 12.1 9.1E-02 OK|

| H-Energy 1.01 | 2.9E-04 | 5.4E-02 | 7.2 5.8E-03 OK|

Parallel run: Received message from slave

Slave partition : 4

Slave routine : ErrAction

Master location : RCVBUF,MSGTAG=1032

Message label : 001100279

Message follows below - :

| ERROR #001100279 has occurred in subroutine ErrAction. | Message: | c_fpx_handler: Overflow

Re: ERROR #001100279
 

There was an overflow in the solver i.e. solution diverged/crashed. Read the section in the manual entitled "Advice on flow modelling".