 |
 |
 |
|
|
|
[Sponsors] | ||||
June 5, 2020, 06:35
|
Axial Turbine Rotor in CFX
|
#1 |
|
New Member
Michael Jeremy
Join Date: Jan 2020
Posts: 8
Rep Power: 6  |
Hi, Im currently simulating the rotor of an axial turbine with 80000 rpm rotational speed. I have mass flow rate and total temperature as inlet B.C. and static pressure at the outlet. The problem is there is so much differences between properties at results and properties from theoretical approach. Even the velocity is increasing. Can anybody tell me what is wrong with my system ? The system, B.C., and results are attached. Thanks.
p.s. i have no issues in achieving 1e-6 rms residual. domainsetup.png VelocityAxial.png Velocityl.png setup.PNG |
|
|
|
|
|
June 5, 2020, 09:22
|
|
#2 |
|
Senior Member
Join Date: Jun 2009
Posts: 1,804
Rep Power: 32 |
Your image for the setup does not match your description of the BC's.
Not clear what your question is.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with an Axial Pump Impeller Mesh / Geometry - ANSYS CFX | davidvalladares | CFX | 1 | May 15, 2018 18:30 |
| Flow in an Axial Rotor /Stator -Ansys CFX Tutorials | amiza83 | CFX | 4 | July 4, 2017 04:22 |
| Simulation of flow through a Pump as turbine by Ansys CFX | Aladinos05 | CFX | 6 | June 13, 2017 21:34 |
| Axial Flow Turbine Problem | Manish | FLUENT | 1 | February 14, 2017 03:46 |
| Axial Thrust in a Radial Turbine | Amit Roghs | CFX | 3 | May 31, 2010 16:47 |
Linear Mode
