Home > Forums > Software User Forums > ANSYS > CFX

generate different mesh in CFX_MESH

Mark Forums Read

Reply

Search this Thread

June 23, 2006, 10:09	generate different mesh in CFX_MESH	#1
Eric Guest Posts: n/a	Dear friends, My model is a little cylinder connected with a "big" box. Fluid flows from cylinder into that big box. I use CFX-Mesh to generate the mesh. For that little cylinder, I need fine mesh. For that big box, coarse mesh is OK. But I didnot know how to bulid "them" in two parts(actually they are is a whole) in Workbench for different kind of mesh. Best regards Eric

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 01:27
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 05:24
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 20:43
[snappyHexMesh] SnappyHexMesh not generate mesh first time	mavimo	OpenFOAM Meshing & Mesh Conversion	4	August 26, 2008 08:08
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 10:38

All times are GMT -4. The time now is 01:11.