|
[Sponsors] |
"The following unrecognised name was referenced: Velocity." |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 9, 2020, 09:13 |
"The following unrecognised name was referenced: Velocity."
|
#1 |
New Member
Join Date: Jul 2020
Posts: 2
Rep Power: 0 |
Hi everyone,
I am a beginner in ANSYS but I am managed to run my simulations. Everything runs fine with the mesh, setup, and solver. The solver finishes the simulations without any mistake but the following error message appears when (and only at that moment) opening the results visualization (also displayed in the file in attachment): "The following unrecognised name was referenced: Velocity." "Variable 'Velocity' is not valid in domain '/DATA READER/CASE:Case CFX/DOMAIN:agua'." "Null pointer to m_geom." Because of that, I can see all variables in all the solids domains but the fluid domains appears in grey and I cannot see any variable such as the temperature in these fluid domains (I have 3 different fluids). Otherwise, the simulations seems to work properly as I have heat transfer between the different domains (because of some power sub-domains in some of the fluids and solids); inclusively between solids separated by one of the fluids that I cannot visualize. Can you explain why these error messages and why the fluids domains appear in grey in the results section? Thank you in advance, |
|
July 10, 2020, 04:50 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
It appears your results file is corrupt somehow. Can you post your output file?
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
July 10, 2020, 05:45 |
|
#3 |
New Member
Join Date: Jul 2020
Posts: 2
Rep Power: 0 |
dear ghorrocks,
thank you for your reply. I have been with this problem for days but I fortunetly solved it right after my post: it seems that the sooner I posted, the sooner I would have solved the problem. I simply had to reset and clear the generated results as I use to do with the solver. Such a stupid and simple answer! Thanks to that, it now works! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] ICEM Meshing Problem-2D Unstructured | Tariq Ahmed | ANSYS Meshing & Geometry | 0 | August 25, 2016 16:13 |
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
Errors when installing cgns library | wruudf | SU2 Installation | 7 | January 21, 2015 22:55 |
Fluent import warning (referenced node number) | carno | FLUENT | 1 | October 17, 2008 07:51 |