|
[Sponsors] |
August 24, 2006, 09:15 |
cfx-bladegen:angle view
|
#1 |
Guest
Posts: n/a
|
Hello everyone. (1)In the angle view of cfx-bladegen, the M-Prime on the abscissa represents the ""radius"" normalized distance along the meridional curve. I don't know what the "radius" represent. could anybody tell me about it in detail or some references about the "radius normalized meridional distance" . Thanks in advanced!
|
|
August 24, 2006, 11:07 |
Re: cfx-bladegen:angle view
|
#2 |
Guest
Posts: n/a
|
If you plot blade-to-blade surface in dimensional R*Theta-M view, the distance between blade will increase with radius. M' is defined as M/R. Now blade angle will be preserved in Theta-M' view.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Different flow pattern between OpenFOAM and CFX | AirS | OpenFOAM | 0 | January 12, 2010 07:08 |
heat generation in CFX | Ema | CFX | 4 | August 7, 2009 05:39 |
Electronics Enclosure Analysis with CFX | Simulation Engineer | CFX | 1 | April 22, 2009 11:08 |
CFX 10's solutions differ from CFX 5.7's | Atit Koonsrisuk | CFX | 4 | July 26, 2006 11:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |