Home > Forums > Software User Forums > ANSYS > CFX

Inkjet simulation problem

Mark Forums Read

Reply

Search this Thread

September 23, 2006, 09:14	Inkjet simulation problem	#1
Saturn Guest Posts: n/a	Hi,folks I am studying a inkjet nozzle and I want to know the droplet shape within the falling process after the fluid is ejected from the inkjet nozzle. Which multiphase model should I choose, homogeneous free surface model or inhomogeneous free surface model? I'm looking forward to your reply. Thanks.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with torque output from a turbine simulation.	pa-dundas	FLUENT	5	July 17, 2022 05:27
the problem of my transient simulation "Floating point exception: Overflow "	alloveyou	CFX	15	November 22, 2012 11:14
Transient simulation (Problem with massflow and Pressure)	ChristianF	CFX	4	August 22, 2011 21:42
about valve closing problem during ANSYS FSI simulation	ivy	CFX	4	June 8, 2011 21:01
Problem restarting a simulation from an intermediate point.	sergiorbrett	CFX	2	April 21, 2010 17:11

All times are GMT -4. The time now is 22:12.