Home > Forums > Software User Forums > ANSYS > CFX

Simulation of Pelton Turbine: boundary conditions?

Mark Forums Read

Reply

Search this Thread

September 26, 2006, 03:56	Simulation of Pelton Turbine: boundary conditions?	#1
massimo Guest Posts: n/a	Hello, I must simulate a Pelton turbine in CFX 10.0 but I don't know which boundary condition applied for the opening. My question is: how can simulate the air volume around the buckets? Which is the correct opening conditions for this volume? Bye m.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Flow simulation in a Pelton turbine nozzle	fivos	FLUENT	0	April 19, 2011 11:46
New topic on same subject - Flow around race car	Tudor Miron	CFX	15	April 2, 2004 06:18
Please help with flow around car modelling!	Tudor Miron	CFX	17	March 19, 2004 19:23
Boundary conditions?	Tom	Main CFD Forum	0	November 5, 2002 01:54
Need help about boundary conditions for a francis runner flow simulation	Rodrigo Escobar Moragas	Main CFD Forum	1	October 26, 1998 08:20

All times are GMT -4. The time now is 16:46.