 |
 |
 |
|
|
|
[Sponsors] | ||||
September 29, 2006, 03:14
|
Inlet BC temperature
|
#1 |
|
Guest
Posts: n/a
|
Hi, does anybody know why the inlet temperature of the fluid in CFX-Post differs so much from the settings in CFX-Pre. I set for the gas temperature T=1300K and in Post it is after 1200 iteration steps about 500K (conservative) and 1100K (hybrid). Is it important whether to choose "static temperature" or "total temperature" for the inlet bc temperature? Thanks in advance...
|
|
|
||
|
September 29, 2006, 07:40
|
Re: Inlet BC temperature
|
#2 |
|
Guest
Posts: n/a
|
Is it important whether to choose "static temperature" or "total temperature" for the inlet bc temperature?
You can choose either one as long as you understand what they each mean. |
|
|
|
||
|
September 29, 2006, 09:38
|
Re: Inlet BC temperature
|
#3 |
|
Guest
Posts: n/a
|
Thank you! Now I found the explanation in "ANSYS CFX-Solver book" page 14-15.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Conjugate heat transfer: coupled wall temperature | Sarah | FLUENT | 7 | August 12, 2013 22:36 |
| [swak4Foam] adjust inlet temperature depending on values of monitor points (groovyBC) | braennstroem | OpenFOAM Community Contributions | 2 | May 31, 2011 13:45 |
| ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
| Problems with Inlet species | San24 | Siemens | 1 | May 7, 2008 06:29 |
| Inlet table in STAR-CD | Sachin | Siemens | 1 | March 26, 2008 10:22 |
Linear Mode
