|
[Sponsors] |
October 10, 2006, 16:46 |
how to set boundary condition?
|
#1 |
Guest
Posts: n/a
|
I have 2D solution domain on half-width of a duct. The duct is symmetric, one side is duct wall, the other central line of the duct. How to set central line surface (wall or symmetric)? thanks for your reply!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
External Radiation Boundary Condition for Grid Interface | CFD XUE | FLUENT | 0 | July 9, 2010 02:53 |
External Radiation Boundary Condition (Two sided wall), Grid Interface | CFD XUE | FLUENT | 0 | July 8, 2010 06:49 |
how to set up a wall boundary condition according to calculated wall shear stress? | gameoverli | OpenFOAM Pre-Processing | 1 | May 21, 2009 08:28 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
how to set the porous boundary condition | chocheng | FLUENT | 2 | March 22, 2001 13:42 |