|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi all !
I just started using ICEMCFD mesh generator. I have a simple problem when I write the solver file for CFX version 10 and find that when I choose the type of solver as ANSYS CFX. The program then produces a output file with extension .cfx5 which obviously does not work with CFX version 10. What do I need to do ? Thanks Steven |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi,
You have to load mesh as "ICEM CFD" (in CFX-Pre mesh format). The program (CFX) should recognize your ".cfx5" file. Pay attention to mesh units Ermanno |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
If you run ICEM CFD in Workbench, you will get output file in .gtm format when you select ANSYS CFX as solver.
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
I think his problem should be solved by choosing the right format as Ermanno said.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with SIMPLE algorithm | katakgoreng | Main CFD Forum | 4 | December 28, 2009 04:09 |
A simple heat transfer problem ? | iggor | FLUENT | 1 | June 15, 2009 04:42 |
1D thermal stress problem simple barrodbeam | newsboost | OpenFOAM Running, Solving & CFD | 3 | January 2, 2009 15:12 |
problem with very simple ufd | Ralf Schmidt | FLUENT | 4 | September 15, 2006 10:38 |
? Simple CFD problem | Davy | Main CFD Forum | 0 | August 21, 1998 06:19 |