 |
 |
 |
|
|
|
[Sponsors] | ||||
October 16, 2006, 04:47
|
forced convection
|
#1 |
|
Guest
Posts: n/a
|
Hi!I have to calculate the heat transfer coefficient between a moving fluid and a wall.Until now I obtained very high results far from I expected (for water moving in a tube 15 millimeters wide I obtained a convection coefficient of about 10^6 W/m^2K, water velocity was about 5 m/s).Can you give me some advice to set this calculation?How I can check mesh near the wall to obtain correct results? Thank'you to all! Bye
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| thermo settings for natural and forced convection | braennstroem | OpenFOAM Running, Solving & CFD | 3 | May 1, 2011 12:33 |
| Coupled vs Seg - Natural vs. Forced Convection | Alex | Siemens | 5 | December 12, 2007 04:58 |
| heat convection in a forced fluid | Daniele | COMSOL | 0 | December 20, 2005 08:09 |
| natural and forced convection | Jan | Main CFD Forum | 4 | November 30, 2005 22:44 |
| giving natural and forced convection bc's | Venu Gopal | FLUENT | 0 | August 29, 2004 10:59 |
Linear Mode
