|
[Sponsors] |
October 18, 2006, 23:17 |
Condense simulation
|
#1 |
Guest
Posts: n/a
|
I am doing a condense simuation using CFX10. It is a simple case that steam inside a pipe is cooled down by outside air.
I have two domains, one for steam and one for air. Can I set different fluids/reference pressure/initial conditions for those two domains? many thanks. |
|
October 23, 2006, 14:46 |
Re: Condense simulation
|
#2 |
Guest
Posts: n/a
|
It is possible, but if you set wich domain with only one material your simulation will be single phase flow!
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why my simulation not agree with the wind tunnel experiment | zhaowei | CFX | 4 | July 11, 2015 03:36 |
Solar Radiation in OpenFOAM | plainstyle | OpenFOAM Running, Solving & CFD | 15 | July 8, 2014 04:43 |
Axial fan simulation in UG/NX 7.5 | fan123 | Main CFD Forum | 2 | April 23, 2011 08:22 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 10:44 |
strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 13:02 |