Home > Forums > Software User Forums > ANSYS > CFX

oulet reference pressure

Updated Threads

Reply

Search this Thread

November 4, 2006, 11:15	oulet reference pressure	#1
bernard Guest Posts: n/a	let say inlet is pressure inlet 2bar, why setting outlet pressure to 0 pa, will result unconverge?

November 5, 2006, 15:24	Re: oulet reference pressure	#2
Glenn Horrocks Guest Posts: n/a	Hi, If you are asking is it possible to set an inlet pressure and an outlet pressure and have the simulation well-posed, the answer is yes. Glenn Horrocks

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
Reference Pressure CFX	solomedic	CFX	12	August 3, 2014 05:22
Installing OpenFOAM-1.5-dev on a cluster	ZKM	OpenFOAM Installation	4	December 25, 2010 15:59
OpenFoam-1.7.x on Suse 11.2 (64bit) does not compile	val46	OpenFOAM Installation	4	August 27, 2010 03:43
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 19:08

All times are GMT -4. The time now is 00:26.