CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   Blocking problem with ICEMCFD (

Charbonnier November 29, 2006 09:16

Blocking problem with ICEMCFD

I have a problem with ICEMCFD and blocking. I must mesh a complex geometry, plenum for turbine blade with approximately 100 holes, and after I create a lot of blocks and Ogrid in holes, the software calculates and dont respond eternally to create a new Ogrid block in a hole.

Is there anybody who knows this problem and has a solution ?


D. Charbonnier

myron November 30, 2006 14:41

Re: Blocking problem with ICEMCFD
Part of the joy of Blocking in ICEM. As the topology gets more and more complex, the response get slower and slower.

All times are GMT -4. The time now is 01:40.