 |
 |
 |
|
|
|
[Sponsors] | ||||
December 15, 2006, 11:05
|
Ansys CFX - Inflation
|
#1 |
|
Guest
Posts: n/a
|
Hello there,
I got a problem with selecting surfaces in CFX-Mesh. There is an volume which is selected as a solid. Inside of this solid is a hollow space, which has several surfaces. I want to select this surfaces for Inflation, but the surrounding solid avoids the selection of all surfaces. Is there an alternative to hide the surface of the surrounding solid? Greetings! |
|
|
||
|
December 15, 2006, 16:10
|
Re: Ansys CFX - Inflation
|
#2 |
|
Guest
Posts: n/a
|
If you include surface in a named selection, you can then hide the named selection.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compressible Flow in Ansys CFX | bcheruk | CFX | 15 | July 6, 2017 06:30 |
| Setting Pressure Boundary Conditions in ANSYS CFX Pre | saisanthoshm88 | CFX | 21 | February 22, 2017 16:50 |
| Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
| ANSYS CFX Tutorial | Rashid | CFX | 25 | December 20, 2012 01:22 |
| CFX bought by Ansys - good or bad?! | Pete | CFX | 38 | February 21, 2003 07:34 |
Linear Mode
