|
[Sponsors] |
January 16, 2007, 23:56 |
problem running the solver
|
#1 |
Guest
Posts: n/a
|
i have a problem to run the solver.is it because my body spacing 3mm consider very small?wut is the limit of sapcing that can be run in the solver?
thank you. |
|
January 17, 2007, 04:59 |
Re: problem running the solver
|
#2 |
Guest
Posts: n/a
|
The thickness of your domain has no influence on the capability of the code to run the solver. Problems can occour when you create cells with too higher aspect ratio, let's say > 100 or more.
Fusion |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RSH problem for parallel running in CFX | Nicola | CFX | 5 | June 18, 2012 19:31 |
Problem Interface Solid Fluid with wall velocity Solver v12 | hills1 | CFX | 2 | October 12, 2009 06:36 |
Compilation problem after modifying a solver. | PetSul | OpenFOAM Running, Solving & CFD | 2 | October 1, 2009 18:28 |
Coupled problem running in parallel | liu | OpenFOAM Running, Solving & CFD | 1 | June 24, 2005 06:57 |
problem in CFX solver about isolated volumes | Yuan | CFX | 2 | August 16, 2004 23:54 |