|
[Sponsors] | |||||
|
|
|
#1 |
|
Guest
Posts: n/a
|
After re-installing CFX10.0 on my computer, a message prompted out every time when I tried to run CFX-Pre (and CFX-Solver mananger, CFX-Post....), which says:
"Aborting due to unexpected error: socketError: RemoteEngineProtocol::receiveTransStat - Communications error: unexpected end of transmission from engine, expected status code." Could anyone please tell me how to solve this problem? P.S.: CFX was installed on the same computer before and had never experienced such a problem. |
|
|
||
|
|
|
#2 |
|
Guest
Posts: n/a
|
Have you updated Internet Explorer to Internet Explorer 7 because CFX 10.0 has compatibility issues with IE7
|
|
|
||
|
|
|
#3 |
|
Guest
Posts: n/a
|
As far as I am concerned, I haven't done anything to my IE
|
|
|
||
|
|
|
#4 |
|
Guest
Posts: n/a
|
I tried to re-install CFX and the Licence manager several times but the problem still exists. The situation now gets even worse: When I tried to enter CFX-Pre from the Launcher, the window of CFX-Pre did not even come up!
Urgent help is highly appreciated!!!!!! |
|
|
||
|
|
|
#5 |
|
Guest
Posts: n/a
|
u have to sereach for the lock files created each time u launch CFX, then delete all of them, this is the first step, the second after u do that and the problem still persist, check the host ID, because if u have lose connection (ex:to network, to internet...) the cfx cannot find the host. it should work then.. tarek
|
|
|
||
![]() |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem About Running Fluent In Linux | mitra | FLUENT | 18 | June 20, 2019 03:11 |
| cfx mesh problem... | mactech001 | ANSYS Meshing & Geometry | 0 | November 5, 2009 03:19 |
| Ansys Workbench (CFX) bucket problem | njsavage | CFX | 1 | April 30, 2009 10:51 |
| Ansys CFX bucket problem | njsavage | Main CFD Forum | 1 | April 30, 2009 10:48 |
| Statically Compiling OpenFOAM Issues | herzfeldd | OpenFOAM Installation | 21 | January 6, 2009 10:38 |