CFD Online Logo CFD Online URL
Home > Forums > CFX

Comparative analysis problem

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   January 23, 2007, 18:59
Default Comparative analysis problem
Giancarlo Páez
Posts: n/a
I made a duct analysis in CFX 10.0 the convergence is ok, after I made some changes in the duct because some assembly restrictions, I simulate the new duct with the same conditions but the analysis don't converge. I only want to compare the dp (preassure) of the original duct and the new duct.

All the conditions are the same, the change is the geometry This is my first analysis in CFX Please help me,

Thanks in advance.

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
area does not match neighbour by ... % -- possible face ordering problem St.Pacholak OpenFOAM 9 November 22, 2011 11:02
Convergence Criterion Problem in RC beam for NON LINEAR analysis chagri ANSYS 0 September 14, 2011 09:24
Gambit - meshing over airfoil wrapping (?) problem JFDC FLUENT 1 July 11, 2011 05:59
Transient 2D analysis residual problem !!! ArslanOZCAN FLUENT 0 January 30, 2011 14:05
Periodic flow boundary condition problem sudha FLUENT 3 April 28, 2004 08:40

All times are GMT -4. The time now is 01:00.