Comparative analysis problem -- CFD Online Discussion Forums

January 23, 2007, 17:59	Comparative analysis problem	#1
Giancarlo Páez Guest Posts: n/a	I made a duct analysis in CFX 10.0 the convergence is ok, after I made some changes in the duct because some assembly restrictions, I simulate the new duct with the same conditions but the analysis don't converge. I only want to compare the dp (preassure) of the original duct and the new duct. All the conditions are the same, the change is the geometry This is my first analysis in CFX Please help me, Thanks in advance.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	10	February 7, 2024 21:50
Convergence Criterion Problem in RC beam for NON LINEAR analysis	chagri	ANSYS	0	September 14, 2011 09:24
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
Transient 2D analysis residual problem !!!	ArslanOZCAN	FLUENT	0	January 30, 2011 13:05
Periodic flow boundary condition problem	sudha	FLUENT	3	April 28, 2004 08:40

All times are GMT -4. The time now is 11:13.