CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   aerofoil problem (

mark January 27, 2007 13:11

aerofoil problem
i have specific co-ordinates for a 2-d aerofoil. i have managed to construct the geometry in ansys by inputting the co-ordinateds in the command prompt. however i cannot seem to do this in workbench. any ideas as to how i can construct the geometry in workbench??

Johnny January 29, 2007 22:02

Re: aerofoil problem
Try using DesignModeler.

mark January 30, 2007 15:23

Re: aerofoil problem
Where can you input specific co-ordinates in design modeller? seeing as i already have the aerofoil constructed in Ansys, is it not possible to simply import it to workbench or open it up somehow? thank you for your help on this it's much appreciated

andy January 30, 2007 19:24

Re: aerofoil problem
depending which ANSYS you have done it in, you should be able to save it as a IGIS file and import that into workbench.

All times are GMT -4. The time now is 22:06.