 |
 |
 |
|
|
|
[Sponsors] | ||||
February 19, 2007, 08:49
|
Cancel a domain in CFX solver
|
#1 |
|
Guest
Posts: n/a
|
My model consists of two domains. The 1st one is the basic one, the 2nd one have been added to adjust the output pressure (it is a collection tank). Any way in CFX solver to do not use , calculate , or take domain 2 in its calculations
|
|
|
||
|
February 19, 2007, 10:09
|
Re: Cancel a domain in CFX solver
|
#2 |
|
Guest
Posts: n/a
|
can you not open it in change it in pre?
|
|
|
|
||
|
February 19, 2007, 11:19
|
Re: Cancel a domain in CFX solver
|
#3 |
|
Guest
Posts: n/a
|
If I cancel domain two in CFX-pre then I have to set the interface connection to be outlet, which is unknown boundary condition for me. This is because actually, it is not an outlet condition. It should be like domain 1 conditions (domain 2 is just a collection tank)
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The ANSYS CFX solver exited with return code 1 | kola77 | CFX | 24 | April 11, 2022 07:32 |
| why the solver reject it? Anyone with experience? | bearcat | CFX | 6 | April 28, 2008 14:08 |
| Proper output of angle of attack in CFX post | Kevin | CFX | 3 | October 18, 2006 12:18 |
| Solver error message!!! | IoSa | CFX | 1 | September 14, 2006 04:48 |
| Import a rectangular domain into CFX 5.7 from ICEM | SKLam | CFX | 9 | March 8, 2006 00:47 |
Linear Mode
