trouble with the 3d model viewer [CFX-Pre]

February 20, 2007, 08:47

Hello,

i run CFX 10 under Linux and i have some problems with the 3d model viewer in the cfx-pre and the cfx-post. it seems that there is no update of the view druring the rotating of the model. if you rotate or move the model after a time there are so many lines that and you can barely see the model.

where is the problem. maybe you can help me.

Thanks Bye

February 21, 2007, 05:14

Did you update your CFX 10.0 to CFX 10.0 SP?

regards,

February 21, 2007, 13:35

no,because i don´t know, that there is an update. where do i get this update?

February 20, 2007, 08:47	trouble with the 3d model viewer [CFX-Pre]	#1
Martin Guest Posts: n/a	Hello, i run CFX 10 under Linux and i have some problems with the 3d model viewer in the cfx-pre and the cfx-post. it seems that there is no update of the view druring the rotating of the model. if you rotate or move the model after a time there are so many lines that and you can barely see the model. where is the problem. maybe you can help me. Thanks Bye

February 21, 2007, 05:14	Re: trouble with the 3d model viewer [CFX-Pre]	#2
Saturn Guest Posts: n/a	Did you update your CFX 10.0 to CFX 10.0 SP? regards,

February 21, 2007, 13:35	Re: trouble with the 3d model viewer [CFX-Pre]	#3
martin Guest Posts: n/a	no,because i don´t know, that there is an update. where do i get this update?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
multiphaseInterFoam for RAS turbulence model	chiven	OpenFOAM Bugs	8	December 6, 2017 02:08
Atomization and Breakup model	xck1986	OpenFOAM	4	May 31, 2014 04:43
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
[Gmsh] trouble with les model in XiFoam after convertion gmshTofoam?	lfgmarc	OpenFOAM Meshing & Mesh Conversion	0	May 24, 2011 23:35
multi fluid mixture model issue	rystokes	CFX	3	August 9, 2009 19:13