|
[Sponsors] |
March 4, 2007, 13:10 |
grid prob
|
#1 |
Guest
Posts: n/a
|
hi all im trying to open a .msh file in fluent, the grids are developed using icemcfd, but for what ever grid ratio i provide fluent shows folowing error cell centriod of thread ------has Null face pointer- error: null domain pointer
can any one fig out the problem . |
|
March 4, 2007, 17:34 |
Re: grid prob
|
#2 |
Guest
Posts: n/a
|
this forum is about cfxxxxxx. Not fluent.
|
|
March 5, 2007, 08:26 |
Re: grid prob
|
#3 |
Guest
Posts: n/a
|
Is this a planar-2D or 3D grid? If planar-2D - make sure you have LINE/BAR elements around the entire outer boundary. (In Hexa/Blocking - edge-to-curve associations....)
|
|
March 5, 2007, 09:24 |
Re: grid prob
|
#4 |
Guest
Posts: n/a
|
its a 3d grid, with hexa mesh n all d assosiations are fine mesh quality is ok!
|
|
March 5, 2007, 18:24 |
Re: grid prob
|
#5 |
Guest
Posts: n/a
|
Also make sure you go through the Edit Mesh > Check Mesh process. Check the defaults for errors and possible problems.
You're outputting for Fluent V6, I suppose. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MapFields to New Grid For Extreme Grid Deformations due to Body Motion | albcem | OpenFOAM | 0 | May 5, 2009 14:17 |
Grid Adaptation | Suresh | FLUENT | 0 | October 15, 2003 13:18 |
GRID TO GRID INTERPOLATION in FLUENT | calogero | FLUENT | 3 | June 4, 2003 08:32 |
Combustion Convergence problems | Art Stretton | Phoenics | 5 | April 2, 2002 05:59 |
Troubles modelling flow through a grid | Hans Klaufus | CFX | 1 | June 28, 2000 16:43 |