Home > Forums > Software User Forums > ANSYS > CFX

mesh has negative volume after refinement

Mark Forums Read

Reply

Search this Thread

February 28, 2007, 21:46	mesh has negative volume after refinement	#1
scott Guest Posts: n/a	When I test a free surface case i turn on the mesh adaption,but after refinement solver got a error about negative volume.anybody met with it before?any help is welcome.thx.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic mesh & Negative volume in 3D	mahzironrazak	FLUENT	97	December 28, 2020 23:09
[snappyHexMesh] snappyHexMesh aborting	Tobi	OpenFOAM Meshing & Mesh Conversion	0	November 10, 2010 04:23
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 15:11
[ICEM] negative mesh volume problem (icem-cfd/cfx)	adam2008	ANSYS Meshing & Geometry	5	April 16, 2010 13:21
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 19:10

All times are GMT -4. The time now is 19:09.