icem 10 - degenerate to y-block -- CFD Online Discussion Forums

March 13, 2007, 05:48	icem 10 - degenerate to y-block	#1
Mark Guest Posts: n/a	I wish to convert a degenerate block (prism) to a y-block topology. however, when i select some of them i get errors like "end face nodes != 3" "degenerate elements must have super edge" what do these mean? regards, Mark

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Multiple fluide zone in ICEM Hexa Block problem	ddqp	ANSYS Meshing & Geometry	4	October 9, 2013 10:57
[ICEM] Unstructured "all quad" mesh in ICEM Block Method	Zeppo	ANSYS Meshing & Geometry	7	November 20, 2012 15:58
[ICEM] Quest for seemingly simple Blocking (degenerate block)	la7low	ANSYS Meshing & Geometry	0	July 12, 2011 19:48
[Commercial meshers] Icem Mesh to Foam	jphandrigan	OpenFOAM Meshing & Mesh Conversion	4	March 9, 2010 02:58
block strategy in ICEM	Li	CFX	1	October 16, 2008 04:20

All times are GMT -4. The time now is 13:25.