|
[Sponsors] |
March 15, 2007, 06:30 |
elementary FSI
|
#1 |
Guest
Posts: n/a
|
Hello,
i am an undergrad mech engg student and i want to do a simulation of an impedance pump and for that i need to use MFX .However i am a beginner so i worked through the tutorial(the ansys tutorial of a micropump with peizoelectric actuation) and then made an very very simple simulation myself to see how the MFX works. However in both cases the solution just happens and i'm left with some files in the working directory. The problem is when i launch cfx post and try to read results it can't find anything it can read or process in the output directory. I check the folder it generates for any file it could open but nothing was there either. As for the ANSYS output file i don't even know what to open it with, or how to open it for that matter. i think i'm making a simple mistake but i am confident i performed the tutorial correctly. can anyone please advise? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BCs in an FSI simulation of a flexble pipe | vivekcfd | OpenFOAM | 10 | January 8, 2010 04:14 |
initial file for fsi modeling? | mortazavi | CFX | 0 | July 21, 2009 02:06 |
fsi | sun | Siemens | 8 | January 19, 2009 23:17 |
how to extend FSI 2D codes to 3D, need advises | abouziar | Main CFD Forum | 1 | May 30, 2008 04:08 |
FSI on a Rotating Structural Model | drgolf | CFX | 9 | August 30, 2007 12:08 |