|
[Sponsors] |
April 17, 2007, 08:49 |
FLoating pint error
|
#1 |
Guest
Posts: n/a
|
I'm running a diffuser case with inlet mass flow and outlet pressure conditions and for some reason the solver exits with the error "Floating point exception : Overflow" I've tried running with a real low physical timescale but with no success. What could possibly be the problem. I thought it could be a High Mach number problem, but the solver gives no "High Mach number" warning as it normally does. Kindly help me out Thanks in advance Luke
|
|
April 17, 2007, 11:31 |
Re: FLoating pint error
|
#2 |
Guest
Posts: n/a
|
More info needed.
|
|
April 17, 2007, 23:30 |
Re: FLoating pint error
|
#3 |
Guest
Posts: n/a
|
This is the error that i get c_fpx_handler: Floating point exception: Overflow
The problem is a diffuser, with inlet mass flow BC and outlet static pressure BC. The analysis goes on with no problems regards to divergence or reverse flow, but at a certain point it exits with this error, with no warning whatsoever. What could be the problem? |
|
April 22, 2007, 08:46 |
Re: FLoating pint error
|
#4 |
Guest
Posts: n/a
|
CFX 11.0 64bit gives that. CFX 10.0 64bit does not. 11.0 possibly came out too early.
|
|
April 23, 2007, 07:33 |
Re: FLoating pint error
|
#5 |
Guest
Posts: n/a
|
I am using CFX 10.0 64 bit.....
|
|
April 24, 2007, 15:55 |
Re: FLoating pint error
|
#6 |
Guest
Posts: n/a
|
Refining mesh would be my way.
|
|
April 25, 2007, 05:00 |
Re: FLoating pint error
|
#7 |
Guest
Posts: n/a
|
If refining the mesh doesnt help. I would switch the outlet boundary condition to an opening and run for couple iterations before switching it back to outlet.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CGNS Compiling | Diego | Main CFD Forum | 17 | December 21, 2014 01:40 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
OpenFOAM install on Ubuntu Natty 11.04 | bkubicek | OpenFOAM | 13 | May 26, 2011 05:48 |
error while running paraFoam! | padmanathan | OpenFOAM | 9 | October 13, 2009 05:17 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |