Viewing Solution Contours During CFX Run

m_amin101 · August 3, 2015, 05:46

Hello everyone,

I was wondering if it was possible to monitor solutions contours (Velcoity, pressure..etc) during a CFX run where it would update for every time-step. This is possible in Fluent through "Calculation Activities"

Thanks,

ghorrocks · August 3, 2015, 06:16

Yes, you can do this. But it is not elegant.

If you are saving results files (which include the mesh) as the simulation progresses you can load these in CFD-Post and view them. These files will be located in the CFX run temporary directory which can be a little tricky to find if you are running workbench.

August 3, 2015, 05:46	Viewing Solution Contours During CFX Run	#1
m_amin101 New Member Moataz Amin Abdulhafez Join Date: Jun 2015 Posts: 1 Rep Power: 0	Hello everyone, I was wondering if it was possible to monitor solutions contours (Velcoity, pressure..etc) during a CFX run where it would update for every time-step. This is possible in Fluent through "Calculation Activities" Thanks,

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
unable to run solution in cfx	arshbunny	CFX	0	June 7, 2014 09:44
Help with executing macros at specific timesteps during the solution run	Codophobia	Fluent UDF and Scheme Programming	1	April 28, 2014 06:16
Immersed solids + Compressible flow + transient solution in recent versions of CFX??	Catthan	CFX	2	May 22, 2012 21:02
viewing cfx post while working on cfx solver manager	HMR	CFX	5	March 9, 2011 22:33
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 15:45

August 3, 2015, 06:16		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Yes, you can do this. But it is not elegant. If you are saving results files (which include the mesh) as the simulation progresses you can load these in CFD-Post and view them. These files will be located in the CFX run temporary directory which can be a little tricky to find if you are running workbench.