Home > Forums > Software User Forums > ANSYS > CFX

Turbogrid Shroud-Hub Mesh Measure Limits. Turbine

Mark Forums Read

Reply

Search this Thread

July 27, 2007, 13:30	Turbogrid Shroud-Hub Mesh Measure Limits. Turbine	#1
Santiago Orrego. Guest Posts: n/a	Hello. Im working with a Francis Turbine. Im making the mesh to the distributor. Im meshing with turbogrid. I want to know some advices of the mesh quality for the Stay vanes mesh and. the guide vane mesh and the blade (runner) mesh. Minimun Face angle? Maximun face angle? Maximun element volumen ratio? Maximun edge lenght ratio? What advice you guys give me, to have a good mesh? those parameters depend on what? I would like to have a reference for those values. Thanks Santiago.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 06:21
Can I use Turbogrid to mesh a wind turbine blade?	Henry Liu	CFX	10	November 10, 2011 05:41
engrid -> save as .stl with boundarie codes	Zymon	enGrid	31	August 29, 2011 13:40
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

All times are GMT -4. The time now is 02:34.