CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   Floating Front node (

Khaled July 30, 2007 14:37

Floating Front node
Dear All,

I have been receiving the following 'internal error' message when I try to mesh my geometry: 'Number of floating front nodes detected = 1'. Can someone please clarify what is meant by this error? Note that I do have a section of a sphere in my geometry, which is a 360 degrees continuous surface. How can this error be resolved or avoided? your feedback would be greatly appreciated.

Regards, Khaled

All times are GMT -4. The time now is 12:58.