|
[Sponsors] |
August 24, 2007, 11:10 |
Nozzle Flow Simulation
|
#1 |
Guest
Posts: n/a
|
Dear,
Actually, I'm pretty new with the simulation by using CFX and would like some kind of suggestion which can help me to start this correctly. My problem is the nozzle jet which will spray Nitrogen on to target at the height of a few hundred micron. Therefore, I would like to simulation the flow effect which probably mass flow or pressure over my target to evaluate my nozzle design. I'd start from my nozzle with 2 domains and both domain has different fluid property. Anyway, please kindly comment the I can start it up correctly and Thank you so much indeed. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help with slug flow simulation. | Kes | FLUENT | 3 | November 9, 2019 22:39 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 11:44 |
Wing lift in Solidwork Flow Simulation | brianmcv | Main CFD Forum | 6 | April 11, 2011 09:16 |
Simulation of steam (CO2 and Water vapor mixture) flow through nozzle using Fluent. | Jimmy | FLUENT | 0 | March 2, 2011 13:30 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 22:31 |