|
[Sponsors] |
September 3, 2007, 04:12 |
Variables
|
#1 |
Guest
Posts: n/a
|
Hi I ran a transient simulation I am suprised that I didnt have most of the variables available in use in cfx post
What may be the reason? I couldnt reach Wall Heat Flux,Temprature,Pressure etc? Thanks in advance Selim |
|
September 3, 2007, 18:18 |
Re: Variables
|
#2 |
Guest
Posts: n/a
|
Hi,
Did you select "selected variables" in the result file options in CFX-Pre? That is probably the cause. Glenn Horrocks |
|
September 6, 2007, 10:51 |
Re: Variables
|
#3 |
Guest
Posts: n/a
|
Glenn is right. In the Transient output control try to select all the variables that you need as an output for Postprocessing them.
Or else, it would only store some default variable values. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ADDITIONAL VARIABLES LIMITERS | N.P | CFX | 5 | December 1, 2011 07:47 |
$FOAM_USER_APPBIN & LIBBIN variables not set | rassilon | OpenFOAM Installation | 2 | February 16, 2010 20:54 |
How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 10:15 |
PHI file structure | Eugene | Phoenics | 9 | November 2, 2001 22:00 |
Saving variables on a user patch with physical coordinates | Zoltan Turzo | CFX | 2 | April 20, 2000 15:05 |