CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

"interior" face definition in CFX

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   September 12, 2007, 07:19
Default "interior" face definition in CFX
  #1
Anish
Guest
 
Posts: n/a
how do i define a face in CFX which is usually defined as "Interior" in FLUENT??
  Reply With Quote

Old   September 12, 2007, 10:13
Default Re: "interior" face definition in CFX
  #2
CycLone
Guest
 
Posts: n/a
If the mesh region exists, just apply a wall to the region and select the option "Create Thin Surface Partner", which will create a corresponding wall on the other side of the thin surface. Note that Pre will have already split a single interior region into two primitive regions when the mesh was imported.

-CycLone
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
ATTENTION! Reliability problems in CFX 5.7 Joseph CFX 14 April 20, 2010 16:45
Different flow pattern between OpenFOAM and CFX AirS OpenFOAM 0 January 12, 2010 08:08
CFX doesn't continue calculation... mactech001 CFX 6 November 15, 2009 22:25
heat generation in CFX Ema CFX 4 August 7, 2009 06:39
Electronics Enclosure Analysis with CFX Simulation Engineer CFX 1 April 22, 2009 12:08


All times are GMT -4. The time now is 04:29.