|
[Sponsors] |
September 21, 2007, 13:30 |
Reaction Issues
|
#1 |
Guest
Posts: n/a
|
Hi, I'm working on modeling a multiphase flow with reactions occurring in the gaseous phase only. I have a well converged solution for the flow with inter-phase mass transfer between the liquid flow and the gaseous flow which I am using as my initial conditions. Yet when I introduce the reactions, the solution oscillates about a constant value. I've attempted refining the mesh, but that didn't provide me with any better results.
I've run other simulations with reactions without problem before, but this case is causing me a lot of grief. If anyone has any insights in dealing with this type of system I'd appreciate it. |
|
September 21, 2007, 16:32 |
Re: Reaction Issues
|
#2 |
Guest
Posts: n/a
|
Did you change the time step also?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Segmentation fault in running alternateSteadyReactingFoam,why? | NewKid | OpenFOAM | 18 | January 20, 2011 16:55 |
reaction in UDF(DEFINE_VR_RATE) | louiza | FLUENT | 3 | October 13, 2010 23:59 |
CFX5.7 - chemical reaction problem... | H.L. | CFX | 4 | March 25, 2009 10:33 |
chemical reaction - decompostition | La S. Hyuck | CFX | 1 | May 23, 2001 00:07 |
chemical reaction - howto | Dan Sorensen | Siemens | 1 | February 21, 2000 09:20 |