|
[Sponsors] |
October 12, 2007, 16:16 |
Editing current run or definition file.
|
#1 |
Guest
Posts: n/a
|
Hi,
Few more doubts !!!! 1) In CFX-solver>Tools>'Edit Definition File' or 'Edit run in progress' , I see that we can only edit the parameters which appear in GREEN color. The 'Simulation type' ('steady or unsteady state') and 'turbulence models' do not appear in GREEN color and hence can not be changed. Is there any way out to do that ???? I got an impression from one fluent user that it is possible to do in Fluent. Thanks a lot for the information, Best Regards, KM. |
|
October 12, 2007, 17:43 |
Re: Editing current run or definition file.
|
#2 |
Guest
Posts: n/a
|
Dear KM,
In CFX, only certain parameters can be changed at run time using the CFX-Solver Manager editor. For those that do not appear in GREEN, you must create a new definition file in CFX-Pre and restart your simulation using your previous results. Opaque |
|
October 12, 2007, 17:46 |
Re: Editing current run or definition file.
|
#3 |
Guest
Posts: n/a
|
Thanks a ton !!!! It helps. Regards, KM.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |