 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2007, 13:52
|
Simulate a mass source in the tank
|
#1 |
|
Guest
Posts: n/a
|
Does anybody know how to model a mass source in a heat exchanger tank? The mass source is simulate the leakage of the heating fluid in the coil heating tube. Thank you.
|
|
|
||
|
October 21, 2007, 23:07
|
Re: Simulate a mass source in the tank
|
#2 |
|
Guest
Posts: n/a
|
Hi,
Mass sources are discussed in the documentation. Glenn Horrocks |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
| [Gmsh] Compiling gmshFoam with OpenFOAM-1.5 | BlGene | OpenFOAM Meshing & Mesh Conversion | 10 | August 6, 2009 05:26 |
| mass source and mass sink for multi-component | frank | CFX | 0 | May 14, 2008 12:55 |
| About units of mass source term | bg2306 | FLUENT | 0 | April 1, 2005 12:46 |
Linear Mode
