Home > Forums > Software User Forums > ANSYS > CFX

Simulate a mass source in the tank

Mark Forums Read

Reply

Search this Thread

October 19, 2007, 12:52	Simulate a mass source in the tank	#1
Brian Zhang Guest Posts: n/a	Does anybody know how to model a mass source in a heat exchanger tank? The mass source is simulate the leakage of the heating fluid in the coil heating tube. Thank you.

October 21, 2007, 22:07	Re: Simulate a mass source in the tank	#2
Glenn Horrocks Guest Posts: n/a	Hi, Mass sources are discussed in the documentation. Glenn Horrocks

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
[Gmsh] Compiling gmshFoam with OpenFOAM-1.5	BlGene	OpenFOAM Meshing & Mesh Conversion	10	August 6, 2009 04:26
mass source and mass sink for multi-component	frank	CFX	0	May 14, 2008 11:55
About units of mass source term	bg2306	FLUENT	0	April 1, 2005 11:46

All times are GMT -4. The time now is 05:47.