 |
 |
 |
|
|
|
[Sponsors] | ||||
October 28, 2007, 11:37
|
Error importing blade in DesignModeler
|
#1 |
|
Guest
Posts: n/a
|
I'm trying to edit in DesignModeler a turbine created in BladeGen, but there is a message error: "ImportBGD doesn't support the Trim Meridional Profile.".
Does anybody know how to fix it? Thanks! |
|
|
||
|
November 6, 2007, 00:56
|
Re: Error importing blade in DesignModeler
|
#2 |
|
Guest
Posts: n/a
|
hi sandman!
in the output section of bladegen click on use design profile,then save and import in bladegen.it will work. |
|
|
|
||
|
November 7, 2007, 19:05
|
Re: Error importing blade in DesignModeler
|
#3 |
|
Guest
Posts: n/a
|
Thanks, Pankaj!
It worked! |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to create wind turbine blade in DesignModeler | Atit | CFX | 5 | December 26, 2012 06:13 |
| Calculating lift force of a wind turbine blade problem | LittleBart | CFX | 4 | June 29, 2011 02:33 |
| Rotating blade in circular/square vessel (Salome+OpenFoam) | voingiappone | OpenFOAM | 0 | May 19, 2011 11:38 |
| stress analysis of a rotating beam(wind blade) | Cheyannne | ANSYS | 0 | October 19, 2009 17:06 |
| Meshing a 3D, tapered and twisted blade with Gambit-TGrid | teskio | ANSYS Meshing & Geometry | 0 | July 3, 2009 10:36 |
Linear Mode
