Adjust the parameter of the geometry
Hi, everyone, in ICEM CFD, first I have made a cylinder, but later I want to adjust the height of the cylinder and add points to the base surfaces. Every time I have to redraw the geometry, and it is time-consuming. Whether is it possible that just adjusting the parameters of the original geometry? If it is, how?
Thanks a lot! Susan |
Re: Adjust the parameter of the geometry
Hi,
Parametric modelling is best done in Workbench. Glenn Horrocks |
Re: Adjust the parameter of the geometry
Thank you for your reply. I havn't installed the workbench. So it seems that the parameters of geometry can't be adjusted in ICEM.
|
All times are GMT -4. The time now is 23:34. |